Details
GENERAL DATA
Max. Flow: Gpm: 580
Max. Head: Ft: 64'
Pump Type: NON CLOG, SHREDDER
Discharge Size: 4" NPT-F
Min. Submerged Depth: 36.5"
Shipping Weight:Lbs: 393
CONSTRUCTION/MATERIAL DATA
Motor Casing: CAST IRON
Pump Volute: CAST IRON
Strainer / Stand: CAST IRON
Lip Seals & O-Rings: NITRILE BUTADIENE RUBBER
Rotor Shaft: 403 SS
External Hardware: 304 SS
ELECTRICAL/MOTOR DATA
Motor Rating: Hp: 7.5
Motor Rpm: 1750
Motor Insulation Class: F
Motor Service Factor: 1.15
Voltage: 208/230/460/575 - 3PH-60Hz
Motor Protection: TWO NORMALLY CLOSED THERMOSTATS
Power Cord: Gage; Length: A.W.G. 8/4 33', SOOW
Maximum Liquid Temperature: 104°F
Explosion Proof Electric Submersible Pumps with Shredder Action Impellers for use in Class 1, Division 1, Groups C & D Hazardous Locations
XP-SK Series
The Shredder (SK & XP-SK) pumps leave solids slightly larger than if passed through a grinder pump. The shredding action is caused by using a cutting impeller with a Tungsten Carbide Tip, against a "spiral" shaped diffuser plate.
- Shredder Pump - with FM Approved motor for use in Class 1, Division 1, Groups C & D hazardous locations. Available in 208, 230, 460 or 575 Volt 60Hz. Contact factory for 50Hz availability.
- Longer Power Cord – Standard 33ft. power.
- Epoxy Coated Motor Housing – Superior two part epoxy to protect the motor from exposure to the surrounding liquid.
- Three Seal Motor Protection - Motor is protected by two independent mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber. Standard elastomers are Buna N (FKM optional).
- More Motor Protection – Air filled motor with winding protection and (NEMA) Class F motor insulation. Seal leakage detector(s) in seal chamber offers early warning should water enter the chamber.
- Tough Pump Construction – Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components.
Additional Information
Manufacturer: BJM Pumps, LLC
For More Information on the XP-SK Shredder Cutter Pumps XP-SK55C-208T,
[Click Here] to Link to Manufacturer Web Site