SKF Shredder Pumps SK150CF-460T

• Max. Flow: Gpm: 911
• Max. Head: Ft: 101'
• Pump Type: Non Clog Shredder
• Discharge Size: 6" FLANGE,ANSI
• Max. Submerged Depth: 65'
• Shipping Weight:Lbs: 630

• Motor Casing: 304SS
• Pump Volute: Cast Iron
• Strainer / Stand: Cast Iron
• Lip Seals & O-Rings: FKM
• Rotor Shaft: 304SS
• External Hardware: 304SS
• Qty. Oil In Seal Chamber: 87.9 U.S. FL. OZ., SHELL FM 32, NSF APPROVED
• Qty. Oil In Motor Stator: 160 U.S. FL. OZ., OIL-FILLED W/ SHELL FM 32, NSF APPROVED

• Motor Rating: Hp: 20
• Motor Rpm: 1750
• Motor Insulation Class: R
• Motor Service Factor: 1.1
• Voltage: 460/575, 3PH-60 Hz
• Motor Protection: Thermal Sensor Switches Embedded in Each Winding Phase
• Power Cord: Gage; Length: A.W.G. 8/4; 33', high temp. rated
• Maximum Liquid Temperature: 200°F
• Seal Minder: STANDARD

The Shredder (SKF) pumps leave solids slightly larger than if passed through a grinder pump. The shredding action is caused by using a cutting impeller with a Tungsten Carbide Tip, against a "spiral" shaped diffuser plate.

• Longer Power Cord – Standard 33ft. power.
• 304SS Motor Housing – Superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water.
• Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
• More Motor Protection – Winding protection and (NEMA) Class R motor insulation with a thermal cut out switch that will allow the stator to have a winding temperature of up to 300 degrees F (150 C), superior to pumps with Class A and B insulation.
• Tough Pump Construction – Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components.