Details
GENERAL DATA
Max. Flow: Gpm: 95
Max. Head: Ft: 48'
Pump Type: Open Vane Non Clog
Discharge Size: 2" NPT-M
Max. Submerged Depth: 65'
Min. Submerged Depth: 12"
Shipping Weight:Lbs: 75
CONSTRUCTION/MATERIAL DATA
Motor Casing: 316SS
Pump Volute: 316SS
Strainer / Stand: 316SS
Lip Seals & O-Rings: FKM
Rotor Shaft: 316SS
External Hardware: 316SS
Qty. Oil In Seal Chamber: 10.1 U.S. FL. OZ., SHELL FM 32, NSF APPROVED
Qty. Oil In Motor Stator: OIL-FILLED W/ SHELL FM 32, NSF APPROVED
ELECTRICAL/MOTOR DATA
Motor Rating: Hp: 1
Motor Rpm: 3450
Motor Insulation Class: R
Motor Service Factor: 1.1
Voltage: 115/230, 1PH-60Hz
Motor Protection: Thermal Sensor Switches Embedded in Each Winding Phase
Power Cord: Gage; Length: A.W.G. 14/4; 33', high temp. rated
Maximum Liquid Temperature: 200° F
Seal Minder: Standard
316 Cast Stainless Steel Pumps with Single Vane or Double Vane Impellers for Municipal, Industrial and Agricultural Waste-Water.
Side discharge and non-clog single vane impellers for the passing of solids while delivering high volume of liquid.
The SXF-pumps have non-clog, single vane impellers designed for high volume and lift performance.
All wear and "wet" parts such as impeller, wear-plate, oil housing, pump-housing and inner pump top are made of Cast 316 stainless material. The elastomers such as o-rings, lip seals and gaskets are made of FMK. •All parts exposed to pumped liquids are made of 316 Stainless Steel.
- Elastomers are made of FMK.
- Longer Power Cord – Standard 33ft. power cord.
- Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
- More Motor Protection – Winding protection and (NEMA) Class R motor insulation with a thermal cuto out switch that will allow the stator to have a winding temperature of up to 300 degrees F (150 C), superior to pumps with Class A and B insulation.
Additional Information
Manufacturer: BJM Pumps, LLC
For More Information on the SXF Solids Handling Pumps SX750CSSF-115,
[Click Here] to Link to Manufacturer Web Site