Details
GENERAL DATA
Max. Flow: Gpm: 840
Max. Head: Ft: 94'
Pump Type: Horizontal, Vortex
Discharge Size: 4" 150# RF ANSI FLANGE
Min. Submerged Depth: 12"
Shipping Weight:Lbs: 770
CONSTRUCTION/MATERIAL DATA
Motor Casing: 304 SS
Pump Volute: Cast Iron
Strainer / Stand: Cast Iron
Lip Seals & O-Rings: Buna-N
Rotor Shaft: 304 SS
External Hardware: 304 SS
Qty. Oil In Seal Chamber: 7.8 U.S. FL. OZ.
ELECTRICAL/MOTOR DATA
Motor Rating: Hp: 1
Motor Rpm: 3450
Motor Insulation Class: F
Motor Service Factor: 1.1
Voltage: 208/230/460/575, 3PH-60 Hz
Motor Protection: Thermal & Amp Overload
Power Cord: Gage; Length: A.W.G. 16/4; 33', STOW
Maximum Liquid Temperature: 104° F
Seal Minder: Standard/Included
Electric Submersible Pumps with Shredder Action Impellers for Municipal, Industrial and Agricultural Waste-Water
The Shredder (SK) pumps leave solids slightly larger than if passed through a grinder pump. The shredding action is caused by using a cutting impeller with a Tungsten Carbide Tip, against a "spiral" shaped diffuser plate.
- Longer Power Cord – Standard 33ft. power.
- 304SS Motor Housing – Superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water.
- Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
- More Motor Protection – Winding protection and (NEMA) Class F motor insulation allows motor temperature to raise to 230°F, superior to pumps with Class A and B insulation. Automatic switch turns pump motor off if temperature and/or amp draw raises too high. When the motor cools the switch will automatically reset and the pump will turn back on.
- Tough Pump Construction – Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components.
The BJM Shredder Pump model SK08C is not recommended for unscreened sewage. It does not have enough torque to handle solids such as Tampons, Applicators, Sanitary napkins, Paper Towels (bunched), or other similar materials.
BJM Pumps recommend that a 2HP or larger is used in unscreenedsewage.
Choosing the right pump for your particular application is very important. If for any reason you are not familiar with the general rules of sizing a pump or system please contact our Technical Services Department or our nearest distributor for help and guidance.
Additional Information
Manufacturer: BJM Pumps, LLC
For More Information on the SK Shredder / Cutter Pumps SK08C-208T,
[Click Here] to Link to Manufacturer Web Site