Details
The Bullet pumps are ideal for dewatering constructions sites, mines, circulating fountain water, or for all around use in industrial plants and utilities.
- Top Discharge – allows for superior cooling of motor and provides a slim line design.
- Longer Power Cord – Standard 33ft. power cord on pumps ½ HP and below and 50ft. on pumps 1HP and above.
- 304SS Motor Housing – Superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water.
- Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic*. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
- More Motor Protection – Winding protection and (NEMA) Class F motor insulation allows motor temperature to raise to 230°F, superior to pumps with Class A and B insulation. Automatic switch turns pump motor off if temperature and/or amp draw raises too high. When the motor cools the switch will automatically reset and the pump will turn back on.
- Tough Pump Construction – Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components*.
- R400D Special Feature – The mode Up Pumps, will pump down to 1/12 th of an inch. It features a special diaphragm value that prevents water backflow.
GENERAL DATA
Max. Flow: Gpm: 89
Max. Head: Ft: 49.5'
Pump Type: Top Discharge, Dewatering
Strainer Opening: 0.25"
Discharge Size: 2" NPT-M
Max. Submerged Depth: 65'
Shipping Weightibs: 68
CONSTRUCTION/MATERIAL DATA
Motor Casing: 304SS
Pump Volute: Cast Iron
Impeller-Multi Vane: Cast Iron
Lip Seals &0-Rings: Buna-N
Rotor Shaft: 304 SS
External Hardware: 304 SS
Oty. Oil In Seal Chamber: 3.7 U.S. FL OZ.
ELECTRICAL/MOTOR DATA
Motor Rating: Hp: 1
Motor Rpm: 3450
Motor Insulation Class: F
Motor Service Factor: 1.1
Voltage: 115/230,1PH-60HZ
Motor Protection: Thermal & Amp Overload
Power Cord: Gage; Length: A.W.G. 14/3; 50', STOW
Maximum Liquid Temperature: 104° F
Seal Minder: Not Available
Additional Information
Manufacturer: BJM Pumps, LLC
For More Information on the R750-115 Top Discharge Dewatering Pumps,
[Click Here] to Link to Manufacturer Web Site