Details
GENERAL DATA
Max. Flow: Gpm: 100
Max. Head: Ft: 31.5"
Pump Type: Non Clog Vortex
Discharge Size: 3" NPT-M (2" NPT-M optional)
Max. Submerged Depth: 65'
Min. Submerged Depth: 12"
Shipping Weight:Lbs: 68
CONSTRUCTION/MATERIAL DATA
Motor Casing: 304SS
Pump Volute: Cast Iron
Lip Seals & O-Rings: Buna - N
Rotor Shaft: 304SS
External Hardware: 304SS
Qty. Oil In Seal Chamber: 9.3 U.S. FL. OZ., SHELL FM 32, NSF APPROVED
Qty. Oil In Motor Stator: OIL-FILLED W/ SHELL FM 32, NSF APPROVED
ELECTRICAL/MOTOR DATA
Motor Rating: Hp: 1
Motor Rpm: 3450
Motor Insulation Class: R
Motor Service Factor: 1.1
Voltage: 115/230, 1ph-60 Hz
Motor Protection: Thermal & Amp Overload
Power Cord: Gage; Length: A.W.G. 14/4, 33', high temp. rated
Maximum Liquid Temperature: 200° F
Seal Minder: Standard
The SVF-pumps are equipped with Vortex impellers, undoubtedly the best non-clog impellers ever invented for the handling of mud, raw sewage, viscous liquids, rags, wood chips and other solids. They pass solid up to 90% of pump outlet diameter.
- Longer Power Cord – Standard 50ft. high temperature power cord on pumps.
- 304SS Motor Housing – Superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water.
- Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
- More Motor Protection – Winding protection and (NEMA) Class R motor insulation with a thermal cut out switch that will allow the stator to have a winding temperature of up to 300 degrees F (150 C), superior to pumps with Class A and B insulation.
- Tough Pump Construction – Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components.