Details
GENERAL DATA
Max. Flow: Gpm: 185
Max. Head: Ft: 46'
Pump Type: Non Clog Shredder
Discharge Size: 3" NPT-M
Max. Submerged Depth: 65'
Min. Submerged Depth: 13"
Shipping Weight:Lbs: 95
CONSTRUCTION/MATERIAL DATA
Data Motor Casing: 316SS
Pump Volute: 316SS
Strainer / Stand: 316SS
Lip Seals & O-Rings: FKM
Rotor Shaft: 316SS
External Hardware: 316SS
Qty. Oil In Seal Chamber: 10.1 U.S. FL. OZ.
ELECTRICAL/MOTOR DATA
Motor Rating: Hp: 2
Motor Rpm: 3450
Motor Insulation Class: F
Motor Service Factor: 1.1
Voltage: 208/230/460/575, 3PH-60Hz
Motor Protection: Thermal & Amp Overload
Power Cord: Gage; Length: A.W.G. 16/4; 33', STOW
Maximum Liquid Temperature: 104° F
Seal Minder: Standard/Included
Side discharge and non-clog single vane impellers for the passing of solids while delivering high volume of liquids through 2 - 6 inch pipe.
The Shredder (SKX) type pumps leave solids slightly larger than if passed through a grinder pump. The shredding action is cause by using a cutting impeller with a Tungsten Carbide Tip, against a "spiral" shaped diffuser plate.
The SKX -pumps have non-clog, single vane impellers designed for high volume and lift performance.
All wear and "wet" parts such as impeller, wear-plate, oil housing, pump-housing and inner pump top are made of Cast 316 stainless material. The elastomers such as o-rings, lip seals and gaskets are made of FKM . Standard power cable is made of oil-resistant material. Special installation can be made with EPDM power-cable and elastomers. (BUNA (Nitril) also available).
All parts exposed to pumped liquids are made of 316 Stainless Steel.
Elastomers are made of FKM.
Longer Power Cord – Standard 33ft. power cord.
Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
More Motor Protection – Winding protection and (NEMA) Class F motor insulation allows motor temperature to raise to 230°F, superior to pumps with Class A and B insulation. Automatic switch turns pump motor off if temperature and/or amp draw raises too high. When the motor cools the switch will automatically reset and the pump will turn back on.
Each pump is tested at factory, both for performance as well as safety. Level controls and level control systems are available.
Additional Information
Manufacturer: BJM Pumps, LLC
For More Information on the 316 Stainless Steel Shredder Cutter Pumps SKX15CSS-208T,
[Click Here] to Link to Manufacturer Web Site