Details
GENERAL DATA
Max. Flow: Gpm: 594
Max. Head: Ft: 57'
Pump Type: Slurry
Strainer Opening: 1.375"
Discharge Size: 4" NPT-M (3" NPT-M optional)
Discharge Connection: 3" or 4" Hose Barb optional
Max. Submerged Depth: 65'
Shipping Weight:Lbs: 385
CONSTRUCTION/MATERIAL DATA
Motor Casing: Cast Iron
Pump Volute: Ductile Iron
Impeller - Multi Vane: Hi-Chrome
Lip Seals & O-Rings: Buna - N
Rotor Shaft: 410 SS
External Hardware: 304 SS
Qty. Oil In Seal Chamber: 49 U.S. FL. OZ.
ELECTRICAL/MOTOR DATA
Motor Rating: Hp: 7.5
Motor Rpm: 1750
Motor Insulation Class: H
Motor Service Factor: 1.15
Voltage: 208/230/460/575, 3ph-60Hz
Motor Protection: Thermal & Amp Overload
Power Cord: Gage; Length: A.W.G 10/5; 50', SOOW
Maximum Liquid Temperature: 104° F
Seal Minder: Optional
KZN Heavy Duty Submersible Slurry Pumps with agitator is the choice of industries that face the most difficult pumping
TOP 3 REASONS WHY YOU SHOULD CHOOSE THE KZN…
- EVERY KZN slurry pump is constructed with the following abrasive resistant 28% chrome iron (600 Brinell, 57 Rockwell C) components;
- Agitator - to fluidize settled solids into a slurry.
- Wear plate - replaceable hardened surface on the suction side where erosion would cause a loss of pump performance.
- Semi - open Impeller - to handle abrasive solid concentrations as high as 70% by weight.
- EVERY KZN slurry pump model is protected by;
- Class H motor insulation - and built in amperage ( FLA ) and temperature overload protection.
- Double silicon carbide mechanical seals - in a separate oil filled seal chamber.
- Heavy Duty Lip Seal – additional protection for the mechanical seals.Stainless steel shaft and shaft sleeve – saves on shaft wear due to abrasives and corrosion.
- Pump volutes cast from hardened Ductile Iron - 300 Brinnell hardness; twice as abrasive resistant as standard ductile iron.
- EVERY KZN is a top discharge pump;
KZN heavy duty slurry pumps are utility pumps; frequently dragged from one site to another. The KZN doesn’t have a side discharge connection that can break off or be damaged as it is pulled and pushed into place.
- Top discharge pumps are cooled by pumped liquid - The KZN slurry pumps can pump a sump or pit down to within "inches" of the bottom. A side discharge pump without a cooling jacket must stay submerged to avoid overheating, leaving as much as 3 feet of un-pumped slurry.
- Top discharge means "SLIM" - even the largest model with a 22.75 inch "waistline" will fit down a manhole with a hose attached.
- The KZN’s hardened ductile iron volutes - cast with extra thick walls at the point where pumped slurry enters the discharge.
Additional Information
Manufacturer: BJM Pumps, LLC
For More Information on the KZN Heavy Duty Submersible Slurry Pumps KZN55-208T,
[Click Here] to Link to Manufacturer Web Site